單面鉚接鉚釘，受到使用特殊工具鉚釘機（手動，電動，氣動）鉚。鉚釘，鉚釘芯由專用鉚釘槍，所以鉚鉚接體積膨脹，發揮作用。這種鉚釘，特別適用于不便普通鉚釘鉚）（從兩邊是鉚接場合，它廣泛應用于建筑，汽車，飛機，船舶，機械，電器，家具和其他產品。頭扁開放型盲鉚釘應用最廣泛的適用性能平穩的鉚接場合，自攻螺絲，封閉型鉚釘對需求的高負荷和鉚接場合具有一定的密封性能。

 

一般使用的鉚釘

 

孔大小的鉚釘孔+ 0.1分鐘最大+ 0.2工件厚度一般為45% - 65%的鉚釘長度，最好不大于60%。短長度的工作太多麻煩。建議，通常50% - 60%為準。例如：如果2個或以上的總厚度的工件毫米那么鉚釘應該能夠選擇的長度應該是9.23 ---一十三點三毫米。這是其中最好的12毫米長，更合適。氣動鉚釘槍--------------直接向氣磅小螺絲鉆，如載以下是除了6.4（6）直徑。可以拉。6.4（6），有些槍可以拉然而，更昂貴的外國！

 

 

 

   One-sided riveting rivets, subject to the use of special tools - riveters (manual, electric, pneumatic) riveting. Riveted, the rivet core driven by special riveting gun, so riveting volume expansion, play riveted role. Such rivets are especially suitable for the inconvenience ordinary rivet riveting) (from both sides to be riveting occasions, it is widely used in construction, automotive , on ships, aircraft, machinery, appliances, furniture and other products. Head which oblate to open type blind rivets application most widely applicable to the performance of smooth riveting occasions, self tapping screws, closed rivets for on demand with higher loads and riveting occasions with certain sealing performance.

 

 

    Hole size of the rivet holes +0.1 min. Max +0.2 workpiece thickness is generally 45% of the rivet length - 65%, preferably not higher than 60%. Too short length of the work is too much trouble. Recommendations usually 50% - 60% shall prevail. For example: If two or more of the total thickness of the workpiece is 6mm then the rivet should be able to choose the length should be 9.23 --- 13.3mm. this is the case among the best 12mm long, is more appropriate. pneumatic blind rivets gun -------------- directly to the gas pounds on small drilling screws, such as 14kg following is in addition to 6.4 (6) diameter. else can pull .6.4 (6), some guns can pull However, expensive foreign more!